PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home | First message in thread | Previous message

Re[2]: NUTONE INTERCOM SYSTEM

jim Posted Feb 17, 2005, in response to:Douglas Lee

Hi: I just had the same problem with my Intercom system / what i did was get 4 seperate caps at radio shack as they are all common ground. Just make sure you install the caps in the correct location as it is marked on the outside of the capicator. and make sure you connect the grounds to all 4 post on the circuit board. I installed the caps upright in the same location as the can capicator was in. also there was another cap bad the value of it was 100mfd/15v its a single cap located close to the multi can capicator noted above. hope this works out for you have a good one

Reply

Share |
0 comments



  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed