PECHORIN'S home   account   archive   eshop   globalmediapro
.
.


Post new message


Home

GR-D90U condensation Error

Lynol Stevens Posted Apr 25, 2010

Please send me the info to disconnect the humidity sensor

I have ahd this cammera for a little over two years and have not been able to use it for the past year.

Reply

Share |
1 comment

    Re: GR-D90U condensation Error

     JB38 Posted Apr 26, 2010

    Info sent via DIRECT e-mail, although it should be pointed out that the info is really sent in two stages with the first being the dew sensor cleaning procedure, however should this procedure fail then the only option left is the second and more complex task of either resetting the memory or disabling the dew sensor circuit. Although anyone thinking on this is strongly advised to observe the under mentioned. -------------------------------------------------------------------------------- - AN IMPORTANT POINT CONCERNING THE MODIFICATION - The instructions given are really aimed at technically minded people of a "practical" hands-on type who are acquaint at working on small electro-mechanical devices of a precision nature or who have a flair for this sort of thing, and so in the interests of not making the situation any worse I would strongly advise anyone who does not really consider themselves as coming into that category NOT to attempt this work, as it involves separating the case and the unscrewing the main circuit board to gain access to the board below it, this requiring the disconnection of ribbon cables etc, it is also necessary to carry out the precision soldering of two "very" narrowly spaced PCB pins so the possession of a fine tipped soldering iron is also absolutely essential plus of course the skill to use same. Taking the above into consideration the qualification mentioned is really a MUST!! It should be emphasised that there are "NO" shortcuts into permanently getting over this problem other than what's been aforementioned, as if the "no dismantling" dew sensor cleaning procedure doesn't help but the "partial dismantling" memory reset "does", even this can only really be adopted as a stop gap measure as the CPU could lock up again at some point in time and indeed in many cases does exactly that!

    Reply




  


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed