Well the answer is with great difficulty, as the side of the camcorder (button side) has to be removed to access the main board, and once done on looking at the very bottom of the circuit board two different width cut out slots will be seen on the bottom edge with a ribbon cable connector situated roughly offset between them, the fuses are located on the outside section of the board with the longest cut out slit. The camcorder uses four fuses, but the ones that should interest to you are called F6101 and F6103, F6101 being a T1.6amp, and F6103 being another 1.6amp. These are not normal fuses but special miniature soldered in types.