PECHORIN'S home   account   archive   eshop   globalmediapro

Post new message

Home | First message in thread | Previous message

Re[5]: Convergence problems on AV-48WP30

Eric Posted Jun 27, 2007, in response to:Jamie

Jamie Forgot to mention, did you try the Tech Adjust Method, rather than the Customer Adjust Method?


Share |
1 comment

    I did do the tech adjust method. I was able to adjust the convergence, but there is still some fairly severe distortion of the red convergence in the upper right corner (most severe example) and other areas of the TV (much less severe.) I had my uncle, who's an electrical engineer who started out as a tv repairman, look at it. We went through all the convergence menus (customer and tech) and he manually adjusted the red gun. At the end he switched the feeds on the red and green circuits. The Green then exhibited the same distortion the red had shown. I have pics posted if that is helpful. h t t p:// h t t p:// h t t p:// h t t p:// Essentially, I'm willing to spend a couple hundred dollars to get a new board if I need it. I just want to justify the purchase and be fairly positive that I will be fixing the problem before I lay out the money.

    Comments 3, Last comment by Jamie Jun 27, 2007


© 2001-2012 - Pechorin's - Contact Us - Report a bug

Pechorin's does not take responsibility for the content of the messages published in the Forum.

RSS feed