JVC service or questions

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better.

Stacy Sample
JVC Service & Engineering
Houston, Texas

Reply

• Re: JVC service or questions Christian - 28th Nov 2004 4:15
  I have a JVC GR-D31U and when I try to film something, the screen says the lens cap is on for a few seconds and then I just get a black screen in bothe the LCD screen and the eyepiece.. It plays back stuff that I taped earlier just fine, but I can't record anything now.
  Any ideas?
  http://www.pechorin.com/m/2004/01/30/JVC_service_or_questions-208860-62.html
  
  
  • Re[2]: JVC service or questions
    Paula
    - 9th Dec 2006 15:22
    I have the same camera and same problem! Any Help!!
    
    
• Re: JVC service or questions chad kruszynsky - 28th Nov 2004 4:41
  My JVC RX-707V digital surround sound reciever was working fine. However I disconnected it and installed it in another room of the house and now when I turn it on I get sound out of the speaker but the sound is extremely low I have to turn the volume almost all the way up the even hear the faintest sound . If you can help me with this problem it would be greatly appreciated.
  
  
  • Re[2]: JVC service or questions Scott Ashby - 16th Jun 2006 19:10
    try the tape 2 monitor...deselect that button
    
    
• Re: JVC service or questions Elmer Sloan - 28th Nov 2004 15:11
  I have a jvc c-2010 made in march of 1991,it has been a good tv but recently my remote is mia dont know dont care the kids were involved and I havnt seen it since so I figure its just gone.Problem is across the center to right hand side at the bottom it says clock stopped and it wont go away!I tryed adjudting it but without the remote there is no way to bring up the menu,I also tryed unplugging it for overnight but that didnt help,any suggestions would be great.Thanks for your time,and thanks to my kids for eating my remote!Mr. Sloan.
  
  
• Re: JVC service or questions
  marvin Ramsey
  - 28th Nov 2004 18:42
  I have a jvc cam corder model #gr-sxm740 my problem is that it has started eating tapes the error msg tells me to unload and reload the battery which I have done. please advise
  
  
• Re: JVC service or questions
  shannon
  - 28th Nov 2004 21:29
  my jvc tv - av-65wp74 was playing, then a thumping noise started and the set shut itself off. When i turned it back on, no picture or sound just the same thumping noise through the speakers.
  
  
  • Re[2]: JVC service or questions Barry - 6th Sep 2005 16:53
    I have this same problem and I opened the front up and saw smoke coming from one the bulbs.
    
    
  • Re[2]: JVC service or questions
    Tom
    - 2nd Nov 2005 1:31
    I have a JVC 56" Rear Proj Hi-Def TV model #AV-65WP74. As Shannon experienced, it started making a "thumping" noise through the speakers and shut down. The only sign of life was the blue light on the power button fading in and out. I un-plugged and then re-powered it with the same results. A local repair shop had to take it back to their shop to work on it. They called today to tell me that the "high-voltage transformer" had to be replaced at a cost of $570.00 to $630.00. Does this sound accurate? Is this a realistic repair cost? I researched repair parts costs on-line @ Partstore.com and couldnt find any such part name or description. This set isn't even 3 years old. At this point I need to decide if it's worth repairing or buying a new set. If nothing else, this is probably a good example of the justification for an extended warranty. Please provide your feedback ASAP. I feel like I'm living in the dark ages without my big-screen! Many thanks, Tom
    
    
    • Re[3]: JVC service or questions sal loera - 24th Sep 2006 22:53
      I have a 65" set that has done the same thing, and I am unwilling to spend over 500bucks on it, I spent 350 to replace the convergence chips 5 months ago I probably will just replace it I was wondering if you ever got any results with your set appreciate a word please write me if you can sloera5714@sbcglobal.net thanks
      
      
  • Re[2]: JVC service or questions nick - 7th Nov 2006 7:38
    My father has the same TV, He had a repair guy come and fix it for 300 bucks and it died about a week later had anyone figured out the problem yet?
    
    
• Re: JVC service or questions Tommy ballew - 28th Nov 2004 21:55
  We have a 32" JVC tv. Upon turning it on, after about 20 seconds, a black spot appears and takes over about 80% of the TV. Is the tube or tuner going bad?
  
  
• Re: JVC service or questions annf11 - 28th Nov 2004 22:13
  JVC model AV-27D302. The vertical on top is coming back down upside down over the rest of the picture. We can't reset it from the menu or remote or from the back of the TV. Can you tell me whether it is something we can adjust ourselves? If not, can you estimate what it might cost to repair?
  
  
  • Re: Re: JVC service or questions
    Travis
    - 26th Dec 2004 18:36
    Hi I've got a similar problem, my JVC AV2600-CA has the bottom few inches inverted upward so that it operates backwards.
    
    
  • Re[2]: JVC service or questions Jim Onofrey - 8th Feb 2005 2:58
    I have the same vertical black on top with some of the picture inverted. JVC 800 number told me to unplug the set for a couple of hours and to retry. It didn't help mine though. Any suggestions? How do I get into the service mode to see if anything shows up there? Any help appreciated. Thanks, Jim
    
    
  • Re[2]: JVC service or questions
    Fanliang
    - 10th Jan 2007 5:16
    My TV has the same problem with the first one, and my remote controller connot type in 'diaplay', '7', '8', '9'. Can you tell me how to solve this problem please?
    
    
  • Re[2]: JVC service or questions some guy - 26th Mar 2007 17:36
    I have this going on too. I looking on Google and theres a lot of these crape JVC's doing this. Something with the Electrolytic capacitor in the Vertical Oscillator. I've been told to just replace the Vertical circuit or some random capacitors on it..
    
    
• Re: JVC service or questions john row - 29th Nov 2004 2:31
  i have a jvc av36d502 that's got mts I can't find it in the menu though. can you help?
  John Row
  
  
  • Re: Re: JVC service or questions
    duh
    - 30th Nov 2004 6:54
    found it has to be on TV mode boy do i feel dumb lol john row
    
    
• JVC digital camera darren yeo - 29th Nov 2004 6:12
  I have a JVC GR-Dx 75AG digital video camera.
  Recently i can not see any picture during recording. The whole LCD is black eventhough the lens cap is open. I last used it about 2 mths ago.
  However during playback it works.
  
  
  • Re: JVC digital camera
    rio
    - 30th Nov 2004 6:06
    Oh no... it's same with my problem, please tell me how to fix it, I'm also confused.
    
    
    • Re[2]: JVC digital camera
      James
      - 27th Nov 2005 14:15
      We are having the same problem with ours. We even get the lense cap message. Any help will be appreciated.
      
      
  • Re: JVC digital camera ray - 5th Jul 2006 20:17
    i have the same problem and am searching the net for the solution. any luck with yours?
    
    
• Re: JVC service or questions Jeff Bauer - 29th Nov 2004 20:20
  I have a JVC GR-DVL815U miniDV camcorder and now it is not correctly playing the tapes that I have in it. There is material on the tapes but it treats them like they are blank because there is no timecode, date, sound, or picture from the material on the tape. The camera can rewind fastfoward etc. through the tapes but still it is like they are blank. please help