Re[7]: Error Codes Assistance

if the lamps are fine and the thermal fuses are fine it must be reset by entering the service program mode on the machiene--- cancel 1 0 7 stop {held in for a few seconds} then 5 # then 810 # then 1 # turn the machiene off then back on while the front cover is open

close the front cover for about 5 seconds then open it again
see if the fusing unit is warmer if it is the problem is solved!

if you have any problems... you can e-mail me at cmpelser@yahoo.com OR sbdsolutions@yahoo.com

Reply

• Re[8]: Error Codes Assistance cherian - 21st Sep 2006 15:57
  thank you, i have taken ur advice it was resett problem, now its working fine thanks once again.
  
  there is a brand new canon image class 2300 copier, there is message says PRINTER COVER OPEN" inspite of 2 swicthes in good working condition as well as i have resett printer this message dosent go nor the machine dosent work. i have changed the main PCB even then the error is same( the PBC below, on the base next to power supply board) what could be the reason? is it a manufactures defect? this machine is made in china brought from US. plz give a remedy for this thanks cherry.....