JVC service or questions

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better.

Stacy Sample
JVC Service & Engineering
Houston, Texas

Reply

• Re: JVC service or questions
  chris
  - 23rd Apr 2006 5:56
  I have an AV32F703 that i've had for about 3 years. Randomly, the picture will darken significantly. How do I fix this?
  
  
• Re: JVC service or questions
  Liz Smith
  - 23rd Apr 2006 14:13
  MOdel No. GR-D22U
  Ser. No. 178Z6514
  
  The video camera will not show a picture it shows only black. It will say the lens cover is on when it is not. I can play the tape but it will not tape anything. It will tape the sound.
  
  Please help asap
  
  Liz Smith
  
  
• Re: JVC service or questions
  Kim Dorval
  - 23rd Apr 2006 15:22
  Hi,
  
  I have a JVC Cd Receiver Model No. KD-LX111. And it started appearing the message Err 23 on the screen. And when it happens the display tray keeps popping in and out constantly making the main buttons on-reachables to change the cd mode to radio mode etc..
  
  How can i fix that?
  
  Thanks a lot!
  Kim
  
  
• Re: JVC service or questions Joe - 23rd Apr 2006 20:11
  Hi Stacy:
  I have a JVC TV Model AC-27950 with no vertical height. I do not have any test equipment except a Volt/Ohmmeter and no diagram butI beleive the problem is the Vertical IC, Part NO. IC-421. Also, Could you tell me the value of Resistor R-542. It appears to have over-heated and reads about 20 Meg. Ohms. And where is the best place to buy parts for this TV? Your assistance is very much appreciated.
  
  Joe
  
  
• Re: JVC service or questions Marie-Claire - 24th Apr 2006 21:01
  I am trying to find the driver download for a JVC (analog!) compac camcorder model no GR FXM38EG .When I put in my "in" gate on the pc both A/V (Audio/Video) nothing happens and even putting both cables into the special pink connector witch ends (on the other end) in a S/video cable in connector in the card(all 128 card), the camera is still not detected.
  so impossible to ransform several cassettes into one dvd (digital)
  Thanks
  
  
• Re: JVC service or questions Joe - 25th Apr 2006 13:25
  Hi Stacy:
  I have a JVC TV Model AC-27950 with no vertical height. I do not have any test equipment except a Volt/Ohmmeter and no diagram butI beleive the problem is the Vertical IC, Part NO. IC-421. Also, Could you tell me the value of Resistor R-542. It appears to have over-heated and reads about 20 Meg. Ohms. And where is the best place to buy parts for this TV? Your assistance is very much appreciated.
  My address is Joe Brickey
  4287 Greenwood Drive
  Jonesborough, TN 37659
  
  
• Re: JVC service or questions
  Srinivasa
  - 25th Apr 2006 22:10
  I have a GRD30U
  When I switch it on open the tape door, it says E04 - in safegaurd mode, eject and re-insert tape. Any solutions ? The estimated repair cost is more than half the price of the camcorder
  
  
• Re: JVC service or questions
  SuZan Brown
  - 25th Apr 2006 23:23
  I have a JVC GR-D270U that was purchased in November 2005 and not used until April 2006. Therefore it is NOT under labor warentee and canNOT be returned to the store. The error is "Unit is Safeguard Mode" error #6. Supposedly it will cost more to fix than to purchase another camera. Any sugestions? Thanks
  
  
• Re: JVC service or questions john - 26th Apr 2006 4:19
  Stacy,
  We have a 36" JVC TV model #AV-36950 serial#11330260 dated June 1998 chassis A70.
  When we turn it on it will shut off itself after about 2 hrs. of viewing. We were told to unplug it for 10 mins. then replug it in and it stays on for less and less time after repeating this process until it finally wont come on at all. Independant repair companies have quoted up to $300 to correct this so I would like to fix this on my own if possible. Can you please tell the parts necessary and how to fix it? It would be greatly appreciated . We're a family of 5 on a tight budget so you know where I'm coming from.
  Thanking you in advance for any info,
  Sincerely, John
  
  
• Re: JVC service or questions walied samieh - 26th Apr 2006 7:38
  thank you for helping me
  i have camera JVC GR-DVP3E
  it not work becouse this message unit insafe guard mode
  
  with me best wishes & regardes