JVC service or questions

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better.

Stacy Sample
JVC Service & Engineering
Houston, Texas

Reply

• Re: JVC service or questions RICH SOUCIE - 22nd Jul 2009 21:35
  hi, i have a jvc RX-707V & CAN'T SEEM TO GET THE VOLUME TO ADJ.? SOMEONE SAID TO DISENGAGE THE TAPE2 SWT. THAT DOSEN'T WORK? DO I NEED THE REMOTE CONTROL TO ADJ THE VOLUME? DO YOU HAVE A MANUAL I CAN DOWNLOAD FOR A FEE ? ALL FUNCTIONS ON THE FRONT APPEAR TO WORK & I GET AUDIO OUT OF BOTH CHANNELS, THKS RICH S.
  
  
• Re: JVC service or questions RICH SOUCIE - 22nd Jul 2009 21:39
  hi, i have a jvc rx-707v, can't get the volume to adj? tried disengaging the tape2 swt, no luck, do you have a manual i can download for a fee? thks rich s.
  
  
• Re: JVC service or questions
  Sadiq
  - 25th Jul 2009 5:52
  Hi,
  
  I have a JVC MG130AS Camcorder.
  The camera's zoom is stuck at 34x and I cannot zoom it out.
  On trying to zoom out it goes down to 26x and gets stuck and comes back to 34x.
  On trying to change the zoom settings.
  
  Please guide what can be done in this regard.
  Your help in this would be highly appreciated.
  
  Thanks
  
  Sadiq
  
  
• Re: JVC service or questions
  matthew
  - 25th Jul 2009 20:29
  PLEASE HELP!! - i have a LT26DS6 (FL2 Chassis) that is dead - BUT the main power supply is working fine just not receiveing a on-command (main power) from the CPU (IC7001 - Chassis CPU).
  
  Thanks matthew.
  
  
• Re: JVC service or questions
  glenn
  - 26th Jul 2009 12:23
  how do i set the clock on my jvc kdg535
  
  
• Re: JVC service or questions Bronwyn Wright - 26th Jul 2009 14:59
  I have a JVC GR-SXM250U. When i turn it on i get E06 unit in safe guard mode remove and reattach battery. did that didnt work. HELP!
  
  
• Re: JVC service or questions
  Malcolm Andrews
  - 26th Jul 2009 19:29
  I have a JVC SP-PWM505 model for 3 years. Now when I turn it on the the sub-woofer light does not come on and there is no sound. Please advise.
  
  
• Re: JVC service or questions
  Liz Andersen
  - 27th Jul 2009 11:42
  Hi there
  Model is JVC LT 26C31 BJE
  Volume/speaker problem ..... have had to turn volume up to top level of 50, and have to sit up close to hear it.
  
  Any suggestions on how to put this right, or have the speakers gone?
  thanks
  
  
• Re: JVC service or questions gerald - 29th Jul 2009 4:42
  cannot open tape deck. Shown in the monitor is "E01 unit in safeguard mode"
  
  pls. help
  
  tnx
  
  
• Re: JVC service or questions
  Nicholas
  - 30th Jul 2009 7:17
  PLEASE ASSIST. I have researched on the internet and found that my problem with my JVC I'Art Television Model # AV-32FA54 is quite common with JVC I'Art TV's. After having the TV for about 3 years, it would occasionally just turn itself off, and the front "On Timer" green LED light would blink. I would just pull the AC plug out and then back in to reset the TV and it would be fine. After a year of this intermitent problem, it now does not turn on at all anymore. Now the green light continues to blink after any attempt to reset using the AC plug. The sound comes on for 2 seconds, TV turns off and the front green light blinks. Any suggestions would be appreciated as I am not ready to purchase a new TV after only 4 years of use.
  Thank you very much.