JVC service or questions

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better.

Stacy Sample
JVC Service & Engineering
Houston, Texas

Reply

• Re: JVC service or questions Willie - 31st Mar 2007 17:01
  GR-d244U, won't connect with firewire. why?
  
  willie
  
  
• Re: JVC service or questions amit - 31st Mar 2007 18:08
  hey i have a dvl 300
  and everytime i zoom out to 1x it starts making like rrr noise and wont let me zoom in
  i wahck it and it goes away but then i zoom in and back out to1x and it starts up again.
  this camera also had the e04 errors but they stopped but now the lens problem
  
  
• Re: JVC service or questions Thomas Becks - 31st Mar 2007 20:44
  I have a GR-D30US camcorder by JVC. I have purchased two cleaning heads by Dynex at a local Best Buy. They were purchased because the camera is saying the heads need to be cleaned and the picture is breaking up (pg. 42 in manual) showing that the heads need cleaning. However, when I insert the the mini DV cleaning cassettes the camcorder tells me it is now in the safeguard mode and there is an error at E03 and the tape needs to be ejected and reinserted. Basically, it refuses to run the cleaning tape, but it will run the recorded tapes that I have recently done. How do I clean the heads?
  
  
  • Re[2]: JVC service or questions
    JB38
    - 1st Apr 2007 9:39
    Advice sent via DIRECT e-mail with includes a jpeg attachment for illustration purposes.
    
    
• KD-AVX2 head unit powers on for up to 60 seconds & reboots repeatedly
  Bill
  - 1st Apr 2007 5:45
  I have 2 kd-avx2 head units. One of them has devloped a symptom were when hooked up in the car or on the bench it will power on for anywhere from 20 seconds to a minute. It will then seem to shut down briefly and then come back on, repeating this cycle over & over. Swapped lower system board units between the two avx2s and the problem is definately on the system board somewhere. Any ideas as to what component(s) would cause this failure mode ? Also how long does JVC service usually take to turn around a repair like this ?
  
  
• Re: JVC service or questions Don - 1st Apr 2007 14:32
  Hi
  
  I have a JVC television model number AV-27CM3 made in 1992 that will not turn on.
  
  I looked in the back and found when you try to turn on the tv a little black box near the on button just clicks.
  
  On this black box there is writing. DG1U, 12vDC, TV-5 and DEC-which I think is the company .
  
  Could this be my problem. If so is it worth getting fixed since the tv is 15 years old.
  
  If this is not the problem is there something simple or major.
  
  thanks for your time
  
  
• Re: JVC service or questions
  Manuel Canabal
  - 1st Apr 2007 18:30
  I have JVC Camera GR-250U but it is locked or in safeguard mode, how can I unlock it????
  
  
• Re: JVC service or questions mehdi - 3rd Apr 2007 2:38
  Hello,I'm having a problem with my jvc hxd7 stereo system I turn it on and it turns off after 2 min.with an error message stating protect if you can please get back to me at asap will be greatly appreciated..thank you!!
  
  
• Re: JVC service or questions shaun - 4th Apr 2007 16:54
  Hello Stacy
  
  Please help.I have a JVC TV AV28X37HKE which is about 3 years old. I turned it on and the screen is blank/black although the green on light is illuminated. There is a loud ticking noise from the inside rear of the set which lasts for 3minutes and then the set turns itself to standby displaying the red light for about 2 seconds and then turns itself back on to the same blank screen and ticking noise. This then repeats itself continuously as above. Can anyone explain this problem to me and is it easily fixed by an adjustment or the replacement of a part..????????? Please help..
  
  Shaun
  
  
• Re: JVC service or questions larry crowe - 4th Apr 2007 21:16
  Never have gotten a responce from my october-06 question on the gz-mg37u problem. It's been sitting in the box ever since.
  
  
• Re: JVC service or questions Jared - 5th Apr 2007 3:12
  I have a JVC Compact VHS Camcorder, Model # GR-SXM250U. All features
  seem to work correctly except record function. LCD panel and viewfinder are both black when in record mode. Playback of recording material is black.
  During playback of recorded material recorded prior to trouble is fine.
  Lens cap warning blinks briefly at beginning of playback even though it is
  off. Please assist with any information and troubleshooting tips
  Thanks,
  Jared
  
  
  • Re[2]: JVC service or questions
    JB38
    - 5th Apr 2007 6:20
    Full info on this manufacturing defect sent via "DIRECT" e-mail, which includes details of the procedure used to obtain the "QUALIFIED" free repair.