JVC service or questions

Assistance with JVC product

If anyone has a question regarding a problem with thier JVC product (error codes, safeguard mode etc) write me for troubleshooting assistance. Please provide your model # if available and note this site so I can assist you better.

Stacy Sample
JVC Service & Engineering
Houston, Texas

Reply

• Re: JVC service or questions wayne - 26th Feb 2007 20:26
  How can I unlock a channel without the 3 digit lock code? I have a JVC AV-31BP6
  tv.
  
  Thanks,
  
  --Wayne
  
  
• Re: JVC service or questions Ken - 27th Feb 2007 0:14
  kd-s5050
  Ken - 27th Feb 2007 0:11
  
  Trying to hear the music
  
  I bought a semi used KD-S5050 from a friend with, of course, no manual. After I hooked it up to test it,all looked well, it showed a station and all. When I disconnected to reconnect via harness....I get nothing. The power is there because I can see time and when I insert a CD it shows load and all the lights come on. Then nothing. Any ideas?...Thanks for any help....
  
  
• Re: JVC service or questions
  bob
  - 27th Feb 2007 2:27
  I have a JVC video camcorder, model # GR-AX890U. When I turn it on I can't look through the viewfinder without seeing a whole bunch of fuzzy vertical lines. It also says that I have my lens cap on. ????? Is this a technical fault?
  
  
  • Re[2]: JVC service or questions
    JB38
    - 27th Feb 2007 11:10
    General info sent via reply box, cannot send "FULL" info as your e-mail address was restricted and the info cannot be pasted into a reply box for technical reasons.
    
    
  • Re[2]: JVC service or questions
    JB38
    - 27th Feb 2007 12:10
    The contact e-mail address you provided to Pechorins reply box was rejected. Re the problem though, go into JVC's web page and you will see that your model is covered by the manufacturing fault "free" repair programme.
    
    
• Re: JVC service or questions
  Matt
  - 27th Feb 2007 4:56
  Hello, my 35inch JVC tv was working fine until one moment, while watching it, the signal disappeared and only static was on the screen. We attempted to turn the TV off and then on again, but once turned off, the TV would not turn on, and the standby light wouldn't even come on. We checked the fuse, which was not blown, but we don't know how to proceed from there. Any ideas?
  
  
• Re: JVC service or questions muhammad affendi - 27th Feb 2007 8:33
  Hello stacy....need your expertise...as i have a cam corder JVC GR-D33AG and the problem is my computer doesnt detect the video camera but when i connect it to pc its stated new hardware are installed..when i try to captured to transfer the data the os stated no captured video available...make me confused...Im currently using fire wire cable and Windows XP ..Please assist me through my e mails..
  
  
• Re: JVC service or questions
  Frank K.
  - 27th Feb 2007 18:26
  I am having problems with trying to figure out how to download my video from my JVC camcorder to my PC. So that i can burn it to a DVD. My Camcorder is a JVC 30GB HDD wide screen. Model #GZ-MG77U Hard disk camcorder. I installed all of the software that came with the camcorder. I am able to get the photos of the camera but do not no haw to get the video from hard drive to PC. I went to Best Buy and tried to get help but no one could help me. Can you please give me some input on this. I really would like to be able to get all of the functions of my camcorder. The DVD is the reason i bought this camcorder. I hope that you can shed some life on this for me. From Frank. Just in case you need this info. My PC is a HP Media Center PC m377n w/DVD writer.
  
  
• Re: JVC service or questions samuel danso - 27th Feb 2007 22:30
  i have ajvc tv AV29SX1EK and pressed vol up and down and switch it on tv. now drown a diagram of east and west.has displayed A2.0II WHAT DO I DO
  
  
  • Re[2]: JVC service or questions
    JB38
    - 28th Feb 2007 16:14
    You could try completely unplugging it for a few minutes and trying again, however over the time there has been such a considerable number of upgrade repair kits made for this chassis including an (E/W kit), that its really a bench repair job.
    
    
• Re: JVC service or questions tony - 28th Feb 2007 19:35
  hi can u help my jvc tv av32r250eks wen u swich it on the sound is not working it makes a really loud screeching sound to get rid of the noise you have to swich it on to stand by and then when you swich it back on there is no sound at all.
  
  
• Re: JVC service or questions joey burke - 1st Mar 2007 2:59
  i have a JVC video camera modle:GR-D370U and i am experiancing the blue scree problem it says its recording and i can see what ever im lookiing at when im recording but it dose not play anything back on the camer or the computer any help would be great thanks
  -joey
  
  
• Re: JVC service or questions candace - 1st Mar 2007 3:08
  hey, I would appreciate it if you could help me out. My video camera gr-d72us is having problems with the lcd screen. It will not show anything in record mode. It works ok in playback. The screen is just gray and shows the menu items. I recharged the batteries and checked everything I know but it still does not pick up images. Thanks
  
  
  • Re[2]: JVC service or questions
    JB38
    - 1st Mar 2007 8:12
    "FULL" info sent via direct e-mail which includes details of the free (QUALIFIED) repair being offered on this particular fault.